BlueSky Mast · 200 Standard Series - AL1
Ultralight, man-portable manual push-up mast, built for tactical RF communications and lightning protection systems.
BlueSky is a small defense contractor dedicated to delivering products and solutions that close mission-critical capability gaps for the warfighter.





200 Standard Series - AL1 mast system in the field
Model heights
2 to 10 m (7.5 to 31.5 ft)
Wind loading
70 mph
Deployment
2 to 30 minutes
Transport
One custom 54 x 14 x 14 in wheeling carry bag; optional upgrade to a 62 x 21 x 14 in hard case.
Testing
MIL-STD-810H
200 Standard Series - AL1 mast systems
The 200 Standard Series AL1 is an ultralight, man-portable manual push-up mast that carries 50 lb at 2 m and 30 lb at 10 m. Its patented tripod locks in place with a cam lock system and levels with compass and bubble levels. Lightweight 2 in. OD interlocking mast sections push up by hand, and color coded, free spinning guy rings give directional control. It is built for tactical RF communications and lightning protection systems.

Key features














Key capabilities
01
Radios lose range in ground clutter. The AL1 Standard pushes antennas up by hand on a lightweight tripod mast that one or two people carry in and set up.
02
Remote sites and command posts need a high point for air terminals. The AL1 Standard raises lightning protection rods above the site.
03
Small teams need a mast they can carry in. The ultralight AL1 Standard packs into one 54 x 14 x 14 in. wheeling carry bag and goes up by hand in 2 to 30 minutes.
04
Antennas have to stay aimed once the mast is up. Color coded, free spinning guy rings give directional control, and compass and bubble levels set the tripod plumb.
Choose your mast system
Pick a height to see its schematic, payload, weight and documents.




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing




Payload
System weight
Guying
Testing
In the field
The ultralight push-up mast for tactical RF communications and lightning protection, from the vehicle to the site in one carry bag.





The 200 Standard Series - AL1 is the right mast when integrating TrellisWare TSM radios because it is the lightest push-up mast in the BlueSky line: one or two people raise a TSM relay to 7 m in about 15 minutes, with about 37 lb of capacity at that height. An elevated TSM radio acts as a relay node, stretching the MANET across urban or rough terrain.
Documents and training
| Capabilities Chart |
Search by SKU / keyword:
Search by mast system / category:
350 Lift Series:
Top Plates & Adaptors
Side Arm Kits & Mounts
Pole Mounts & Brackets
Grounding
All 350 Lift Series Compatible
AL1 & AL2:

FAQs
Straight answers on height, payload, setup and transport for the 200 Standard Series - AL1. Need something else? Talk to a mast specialist at 1-877-411-MAST (6278).
See all mast FAQs →How high can a BlueSky Mast go?
Tripod masts reach up to 10 m (AL1 and AL2 Standard), 15 m (200 Lift Series - AL2) and 18 m (350 Lift Series). The vehicle-mounted MEC Series reaches up to 25 m. The Sidekick is a 2 m man-portable mast.
What is the maximum payload a BlueSky Mast can lift?
Payload depends on the mast model and height: the taller the mast, the lighter the allowed payload. On tripod masts the 350 Lift Series carries the most, up to 175 lbs at 5 m. The vehicle-mounted MEC Series lifts up to 400 kg. See the load table on each mast system page for the exact rating at every height.
What wind speed are BlueSky Masts rated for?
200 Series (AL1 and AL2) masts are rated for 70 mph winds up to their maximum deployable payloads. 350 Lift Series masts are rated for 90 mph. See the wind load chart for each system height.
What is the difference between a Standard and a Lift mast?
Standard Series masts are manual push-up systems: the mast sections are inserted by hand up through the tripod. Lift Series masts use a stronger tripod and a self-braking mechanical winch to raise the sections, for a more controlled, easier and safer deployment with heavier payloads.
Can one mast carry more than one device?
Yes. Depending on model and height, a single BlueSky Mast can carry multiple devices at once, such as radios, cameras and radar, using tool-less top plates, pole mounts and side arm kits. That is a core purpose of the modular design.
Do BlueSky Masts need guying?
BlueSky recommends guying every mast using a four-guy configuration at 80% of the total mast height. Mast systems 7 m and above include a primary guy kit. Mast systems 11 m and above include primary and secondary guy kits.
How are BlueSky Masts transported?
AL1 and AL2 Standard systems, and 200 Lift Series - AL2 systems from 2 to 10 m, pack into a single 54 x 14 x 14 in. wheeled carry bag, with an optional hard case upgrade. 200 Lift Series - AL2 systems from 11 to 15 m pack into two 62 x 21 x 14 in. hard cases. The Sidekick packs into a 42 x 9 x 9 in. airline-checkable case. 350 Lift Series systems pack into custom hard cases.
Can the mast be rotated or tilted after it is deployed?
Yes. Interlocking mast sections and free-spinning guy rings let the deployed mast be rotated by hand 360 degrees at the tripod base for directional control, even when guyed. A manual tilt assembly adds +/- 22 degrees of tilt adjustment from the ground (see Top Plates & Adaptors).
Can BlueSky Masts be grounded?
Yes. BlueSky offers certified grounding kits and lightning protection accessories. Combined with the surface wire grounding kit, BlueSky masts have been tested and certified to provide lightning protection equal to or better than an 8 ft copper rod driven into the ground.
What is the outside diameter of the mast?
AL1 and AL2 masts have a 2.0 in. outside diameter (OD). 350 Lift Series masts have a 3.5 in. OD.
What are BlueSky Masts made of?
Masts are black anodized aerospace-grade aluminum alloy, with stainless steel hardware and fasteners blackened to eliminate glare. All BlueSky tripod mast guy ropes are Spectra Cord, a woven fiber 10 times stronger than common cable.
Are BlueSky Masts telescoping or pneumatic?
The tripod masts are sectional, not telescoping or pneumatic: interlocking sections built for portability and rapid deployment. The FM Series (winch-driven) and MEC Series (screw-driven) are telescoping vehicle masts. None are pneumatic.
What is the difference between the AL1, AL2 and 350 Lift masts?
AL1 Standard: the lightest push-up mast, with thin-wall 2 in. OD sections, for single antennas and lightning protection.
AL2 Standard and AL2 Lift: thick-wall 2 in. OD sections (twice the AL1 wall thickness), stiffer and rated for heavier payloads, from 20 to 100 lbs depending on height.
350 Lift: 3.5 in. OD sections for the heaviest payloads, from 50 lbs at 18 m up to 175 lbs at 5 m, rated for 90 mph wind.
What military standards are BlueSky Masts tested to?
The 350 Lift Series, 200 Series tripod masts (AL1 and AL2) and the Sidekick are tested to MIL-STD-810H. Each mast system page lists the standard for that model. The MEC Series is compliant with MIL-STD-810G, 461F, 1275E, 1686C and 464C.
Are BlueSky Masts subject to ITAR?
No. BlueSky Mast equipment is exempt from ITAR. Commodity code 7308200000; ECCN EAR99.
Where can I buy a BlueSky Mast?
Buy directly from BlueSky, or through GSA Contract GS-07F-5916R or the TLS contract. Call 1-877-411-MAST (6278) or use the contact form to get answers before you buy.
How much does a BlueSky Mast cost?
Pricing depends on the model, height and accessories your mission needs. Call 1-877-411-MAST (6278) or use the contact form and we will confirm the right system and issue a no-obligation budgetary quote, valid for up to 30 days.
What is the production lead time?
A single system ships in 2 to 3 business days; up to 20 systems in 3 to 5 business days; more than 20 systems in 5 to 7 business days. Custom accessories are excluded and typically deliver 10 to 20 business days after final drawing approval.
Does BlueSky offer custom design services?
Yes. If a payload does not fit a catalog mount, BlueSky's design team models a custom interface in 3D and puts it into production. Pricing is based on requirements and scope; most custom accessories deliver 10 to 20 business days after final drawing approval.
How tall does the 200 Standard Series AL1 go?
Models range from 2 to 10 meters (7.5 to 31.5 ft), in 1 m steps.
How much weight can the 200 Standard Series AL1 carry?
50 lb at 2 m and 30 lb at 10 m. Payload is the total weight of all devices, accessories and cabling mounted on the mast.
How is the 200 Standard Series AL1 raised?
It is a manual push-up system. One or two people push the lightweight 2 in. OD interlocking mast sections up by hand through a patented cam lock tripod, in 2 to 30 minutes.
Does the 200 Standard Series AL1 need guying?
The 7 to 10 m models ship with a primary guy kit: four red guy ropes, a primary guy ring and four guying stakes. On the 2 to 6 m models a guy kit is optional.
How does the 200 Standard Series AL1 travel?
It packs down into one custom 54 x 14 x 14 inch wheeling carry bag. A 62 x 21 x 14 inch hard case is an optional upgrade.
What wind and testing is the 200 Standard Series AL1 rated for?
70 mph wind loading, tested to MIL-STD-810H.
Next steps
Tell us the payload, height and where it's going. We'll match the configuration and mounts.